Colt earliest Police Positive, New Police, Pocket Positive, New Pocket .22 & .32 revolver, pat dates 1884-1900-1905, produced through about 1925
Colt Pocket Revolver bolt screw #20-28
reproduction This part is manufactured of high quality tool steel and heat-treated to precise spec..
$13.00
Colt Pocket Revolver bolt spring, #154-27A
reproduction This part is manufactured of high quality spring steel and heat-treated to precise sp..
$4.00
Colt Pocket Revolver bolt, takes coil spring #20-27
reproduction This part is manufactured of high quality tool steel and heat-treated to precise spec..
$58.00
Colt Pocket Revolver cylinder assembly .32 S&W Long #20-35A
original used Some parts may need additional fitting to accommodate wear in old firearms. Sorry,..
$130.00
Colt Pocket Revolver ejector spring #20-26
reproduction This part is manufactured of high quality spring steel and heat-treated to precise sp..
$6.00
Colt Pocket Revolver firing pin #154-56103
reproduction This part is manufactured of high quality tool steel and heat-treated to precise spec..
$32.00
Colt Pocket Revolver firing pin rimfire #154-10RF
original used Some parts may need additional fitting to accommodate wear in old firearms. Sorry,..
$30.00
Colt Pocket Revolver firing pin rivet #154-50396
reproduction This part is manufactured of high quality tool steel and heat-treated to precise spec..
$4.00
Colt Pocket Revolver grips, longer, both chipped on lower outside corner #20-41
original used Some parts may need additional fitting to accommodate wear in old firearms. Sorry,..
$35.00
Colt Pocket Revolver grips, longer, genuine factory pearl, minor chips #20-41P
original used Some parts may need additional fitting to accommodate wear in old firearms. Sorry,..
$310.00
Colt Pocket Revolver grips, older, shorter Jay Scott immitation pearl, near new #20-40P
original used Some parts may need additional fitting to accommodate wear in old firearms. Sorry,..
$40.00
Colt Pocket Revolver grips, older, shorter, all chipped on lower inside corners #20-40
original used Some parts may need additional fitting to accommodate wear in old firearms. Sorry,..
$40.00
Colt Pocket Revolver hammer assembly, centerfire, checkered .165 taller than earlier models #20-1TA
Pay particular attention to the size.original used Some parts may need additional fitting to accom..
$120.00
Colt Pocket Revolver hammer assembly, checkered, centerfire #20-1A
Pay particular attention to the size.original used Some parts may need additional fitting to accom..
$120.00
Colt Pocket Revolver hammer assembly, nickel, checkered, centerfire #20-1N
Pay particular attention to the size.original used Some parts may need additional fitting to accom..
$130.00